Units Of Measurement; Safety; Intended Use; Safety Instructions - STIEBEL ELTRON SHU 10 SLi Bedienung Und Installation

OPERATION

Safety

1.3

Units of measurement

Note
All measurements are given in mm unless stated oth-
erwise.
2. Safety
2.1

Intended use

This sealed unvented (pressurised) appliance is intended for heat-
ing domestic hot water. You can use the appliance to supply one
or several draw-off points.
This appliance is intended for domestic use. It can be used safely
by untrained persons. The appliance can also be used in a non-do-
mestic environment, e.g. in a small business, as long as it is used
in the same way.
Any other use beyond that described shall be deemed inappropri-
ate. Observation of these instructions and of instructions for any
accessories used is also part of the correct use of this appliance.
2.2

Safety instructions

WARNING Burns
During operation, the tap can reach temperatures in ex-
cess of 60 °C.
There is a risk of scalding at outlet temperatures >43 °C.
WARNING Injury
!
The temperature selector should only be removed by a
qualified contractor.
WARNING Injury
!
The appliance may be used by children aged 3 and older
and persons with reduced physical, sensory or mental
capabilities or a lack of experience and know-how, pro-
vided that they are supervised or they have been in-
structed on how to use the appliance safely and have
understood the resulting risks. Children aged 3 to 8 years
may only operate the tap connected to the appliance.
Children must never play with the appliance. Children
must never clean the appliance or perform user main-
tenance unless they are supervised.
Where children or persons with limited physical, sensory or men-
tal abilities are allowed to use this appliance, we recommend a
permanent temperature limit. A qualified contractor can set this
limit.
Material losses
!
If the drain pipe of the safety valve is blocked, expanding
water can lead to water damage.
f Never close the drain pipe. f
Material losses
!
The user should protect the appliance and its tap against
frost.
16 | SHU 10 | SH 10 | SH 15
2.3

Test symbols

See type plate on the appliance.
3.

Appliance description

The appliance constantly keeps the water content available at the
preselected temperature. The appliance switches on automatically
as soon as its temperature falls below the set value.
Subject to season, varying cold water temperatures can result in
different maximum mixed water and outlet volumes.
Note
A qualified contractor can set a temperature limit on the
appliance (see "Installation / Settings / Setting the tem-
perature limit").
Note
The appliance is under mains water pressure. The water
volume increases as the cylinder is being heated up. Dur-
ing this process, expansion water drips through the safety
valve. This is a necessary and normal process.
3.1 Operation
You can set any required DHW outlet temperature variably at the
temperature selector. The heat-up indicator illuminates during
the heat-up process.
SHU...
2
1
1 Temperature selector
2 Heat-up indicator
Depending on the system, the actual temperatures may vary from
the set value.
°C = Cold. On this setting, the appliance is protected from
frost. The tap and the water line are not protected.
Eco = Recommended energy saving setting (approx. 60 °C),
minor scaling
82 = Highest selectable temperature
SH...
1
2
www.stiebel-eltron.com