Werbung
Verfügbare Sprachen
Verfügbare Sprachen
EN
Safety Warnings
Read all Warnings and Cautions noted blow. Failure to do so could
result in serious or fatal injury.
Prior to installation of this unit, carefully read and adhere to all
CAUTION, ATTENTION, and ADVICE notices located throughout
this
manual.
Failure to comply with these instructions can cause
serious injury, death, or damage to the unit.
RISK OF SUCTION ENTRAPMENT HAZARD, WHICH, IF NOT
AVOIDED CAN RESULT IN SERIOUS INJURY OR
not block pump suction at the pump or in the pool as this can
cause severe injury or death.
Electrical wiring MUST be installed by a trained professional and
adhere to local code and
regulations.
Avoid electric shock. DO NOT USE power extension cords.
Connect ONLY to a Ground-Fault Circuit Interrupter (GFCI) pow-
er outlet. Consult a Qualified professional electrician for safe and
proper installation of a qualified electrical outlet.
Incorrectly installed equipment may fail, causing severe injuries
or damage to the pump-filter system.
Never submerge the filter and/or pump in water.
Never place the pump or filter in your pool.
Trapped air in the pump-filter system may cause the TANK
COVER to be blown off which can result in death, serious injury, or
damage to the pump-filter
system.
before
operating.
NEVER change the 7 Position Multi-Port-Valve while the system
is operating.
ALWAYS unplug the system before changing the control valve.
Install this product
with a sufficient safety margin
prevent children from using the system to access the pool.
Never PLUG or UNPLUG this unit from an electrical source while
standing in water.
NEVER service this unit with the electrical power cord connected.
Do NOT operate the system while the pool is being used.
KEEP CHILDREN AWAY from all electrical equipment.
NEVER ALLOW CHILDREN TO OPERATE THIS EQUIPMENT.
The Pool Owner should always exercise caution and common
sense when utilizing their swimming pool and operating equip-
ment.
Generel Information
This manual provides information relating to the installation, utiliza-
tion and maintenance of our filtration system. We recommend that
you read this manual in its entirety and keep it for future reference.
The pump included with the filtration system is a horizontal, self-
priming centrifugal pump. For the pump to function correctly, the wa-
ter temperature must not exceed 35°C /95°F. The materials used in
the pump have undergone stringent hydraulic testing and electrical
inspections.
The filter included in the filtration system consists of high-grade pol-
ypropylene (PP). It is seamless and manufactured as a single unit
(absolutely corrosion resistant and resistant to commercially availa-
ble swimming pool chemicals).
standard recommended specifications for the pH- and chlorine-
value).
It is equipped with a container drainage system, pressure
gauge, built-in container components, e.g.bottom strainer for even
water distribution and a stable PE separation wall between the filter
and the fresh water chamber. The filter container comes ready to
plug-in and is supplied with a user-friendly 7 Position Multi-Port
Valve integrated into the tank cover, an approved filter pump with
hair and lint basket, and a plastic base for ready on-site mounting.
Page 6 of 35
DEATH.
Ensure all air is out of system
from the pool to
(Prerequisite: Compliance with the
Read this manual carefully before installation. The filtration system
and pump must be installed in accordance with the standards in ef-
fect.
We decline all responsibility for the consequences of failure to com-
ply with the installation instructions. We recommend that you comply
with the power source instructions to avoid overloading the pump
motor and/or electric shock.
This filtration system is not intended for use by persons with reduced
physical, sensory or mental capabilities, or lack of experience and
knowledge.
Safety notes
and
callout
Do
Safety Notes
Your filter pump was constructed and tested and left the manufactur-
ing plant in technically operational
condition and ensure safe operation, the user should observe the
notes and product information contained in this technical
If there is any indication that safe operation is no longer possible, the
device is to be disconnected from the power supply and secured
against accidental use.
This is the case when:
The device has visible damage
The device no longer appears funcional
After long periods of storage in poor conditions
If the power cord or other parts of this equipment are damaged, they
have to be replaced by the manufacturer or its service agent or a
similarly qualified person in order to avoid danger.
Damage during delivery
Your filter system has been carefully and professionally packed for
delivery.
Please check to ensure that the package is undamaged
and that all parts are in the box. If you purchased this product on or-
der and the product was shipped to you, ensure that delivery is
complete.
Damage to product as a result of shipping is not the re-
sponsibility of the supplier and must be immediately reported to the
shipper.
The shipper assumes the liability for damages during deliv-
ery, the supplier is not responsible for it.
Implied Warranty
The manufacturer warranties safe operation and reliability only under
the following conditions:
The filter system is installed and operated according to the
assembly and operating instructions.
Only original replacement parts are used (consumable
parts do not fall under the warranty).
Expendable parts do not fall under the warranty. These include:
All O-rings
Pressure gauge
Mechanical seal, complete
boxes should always be
observed.
condition.
In order to maintain this
Sandfilter Speedclean 75/50 | 2013_V1
handbook.
Werbung
