Dismantling - Silvercrest SSJ 150 A2 Bedienungsanleitung

NOTE
► If the juice container
dripping out of the juice outlet
stopper
juice outlet
NOTE
► If the container for fruit pulp and vegetable mash
empty it, stop feeding in ingredients and wait until no more fruit pulp comes
out of the
and vegetable mash
► If any fruit pulp remains stuck in the outlet for fruit pulp and vegetable
mash
of the cleaning brush
5) Always switch the off appliance immediately after all of the ingredients have
been processed.
NOTE
► If the motor starts to slow down during operation, switch off the appliance
and move the On/Off switch
succession to reverse the motor. If this does not help, dismantle the slow
juicer as described in the following section.
CAUTION! MATERIAL DAMAGE!
► To avoid blockage and/or damage to the appliance, clean the juice outlet
and the container for fruit pulp and vegetable mash
every use.

Dismantling

If you wish to dismantle the slow juicer, e.g. to clean it, proceed as follows:
1) Pull the plug on the mains cable
2) Close the stopper
drip out.
3) Turn the housing lid
marking on the sieve tray holder
4) Remove the housing lid
5) Carefully lift the sieve tray
sieve
appliance base
6) Separate all the components.
SSJ 150 A2
is full and you want to empty it while juice is still
again after replacing the empty juice container
.
appliance. After emptying, replace the container for fruit pulp
under the outlet for fruit pulp and vegetable mash
, stop the appliance and remove the residue using the handle
.
on the juice outlet
anticlockwise until the
together with the pusher
with the removable sieve frame
or the sorbet attachment
.
, seal it using the stopper
is full and you want to
into the "R" position several times in quick
out of the socket.
so that no remaining juice can
marking points towards the
and clicks firmly into place.
.
and the transport screw
. Remove the
under the
.
regularly and after
and the
from the
GB │ IE │ 45 ■