Nolan N103 Sicherheit Und Gebrauchsanleitung Seite 12

INSTRUCTIONS FOR USE
CHIN GUARD OPENING SYSTEM
This helmet is equipped with the innovative DUAL ACTION chin guard opening system
which prevents it from opening accidentally.
N.B.: It is not necessary to open the chin guard to put the helmet on.
1 OPENING
1.1 Push the red safety lever outwards by turning it with your thumb (Fig. 1).
1.2 Place your forefinger on top of the opening lever and push it downwards so as to
unlock the chin guard (Fig. 2).
1.3 Pull the flip-up chin guard forwards, accompanying it upwards as it rotates (Fig. 3).
2 CLOSING
2.1 Pull the chin guard downwards, accompanying it as it rotates, until you hear the clicks
of the closing mechanism.
2.2 Make sure that the chin guard is properly fastened.
WARNING!!!
- Do not ride the motorcycle with the chin guard open. The chin guard MUST be
closed and fastened while riding the motorcycle.
- Do not use the helmet without the chin guard.
- Do not use the helmet in case of chin guard malfunctioning. Immediately con-
tact a Nolan authorized dealer.
- Do not remove nor tamper the fixing screws that connect the chin guard to the
shell.
• VISOR MECHANISM SYSTEM
1 DISASSEMBLY
1.1 Open the visor completely.
1.2 By pressing the visor release button (A), slide the visor forwards until you hear a click
(Fig. 4).
1.3 Release the visor fastenings (B1 and B2) from their seat (Fig. 5).
1.4 Repeat the same steps on the other side of the helmet.
Warning: do not remove the visor opening/closing mechanisms from the shell.
2 ASSEMBLY
2.1 Turn the visor automatic recovery gear (C) completely forwards as shown in Fig. 6.
2.2 Set the visor in open position by placing the visor fastenings (B1 and B2) into their
seats in the visor mechanism (Fig. 5).
2.3 Insert fastening B1 in the appropriate seat and press the visor against the shell in line with
12