Error Messages; Ordering Data - Testo 535 Bedienungsanleitung

4x
Multi-point mean calculation
1 1 3 3 1 1 0 0
MEAN
0 0
Save required readings by
pressing button.
Timed mean calculation
1 1 3 3 1 1 0 0
MEAN
0 0 0 0 : : 0 0 0 0
The clock starts to run in the display.
Once the measurement has run for as
long as required, press the Start/Stop
button. The duration of the measurement
can be extended by further Start/Stop
intervals lasting up to a total of 99 hours
and 59 minutes.
Return to measuring mode
Height above Air pressure Height above Air pressure
mean sea level (hPa) mean sea level
Mean calculation
1 1 3 3 1 1 0 0
MEAN
0 0 3 3 7 7
Call up reading by pressing button.
This procedure can be repeated 999 times.
The number of readings saved is counted in the display.
1 1 3 3 1 1 0 0
MEAN
1 1 : : 2 2 5 5
The mean of the readings are taken over
a certain period of time. The mean and
duration are shown.
Table: barometric height formula
Height above Air pressure Height above
(hPa) mean sea level (hPa) mean sea level
4
Error message
in display
1 1 4 4 5 5 0 0
MEAN
0 0 3 3 7 7
testo 535 measuring instrument and accessories
1 1 4 4 5 5 0 0
testo 535, CO2 measuring instrument for measuring the quality of ambient air,
MEAN
with securely attached probe, instruction manual, batteries
1 1 : : 2 2 5 5
and calibration protocol
TopSafe (indestructible protection case) with bench stand and
belt clip, to protect instrument from impact, dirt...
9 V rechargeable battery, instead of battery
Recharger for 9 V rechargable battery, for external recharging of 0515.0025 battery
Plug-in mains unit for mains operation
Air pressure Accessory set (for measuring instrument without TopSafe): belt clip, wall holder
(hPa)
and carrying loop
Plastic case for storing measuring instrument, accessories, probes
Testo log printer and accessories
Printer and accessories
Testo log printer, prints measured data with date and time
Recharger with 4 NC rechargeable batteries for the Testo log printer,
rechargeable batteries are recharged externally
Printer paper for Testo log printer (6 rolls)
Cause
Probe out of order Please contact
service point
Measuring range Measuring range
is exceeded. is exceeded.
The readings Does not damage
lie outside the
maximum measuring range
5

Error messages

Remedy
the Testo
probe.

Ordering data

Part no.
0560.5350
0516.0183
0515.0025
0554.0025
0554.0088
0554.0550
0516.3250
Part no.
0554.0545
0554.0110
0554.0569