RADEMACHER RolloTron Basis DuoFern1200 Original - Betriebs- Und Montageanleitung Seite 84

15. Automatic operation
AUTO
Automatic dawn function
The automatic dawn function causes the roller shutters
to open automatically to the upper end point.
The control signals for this function are provided by a
DuoFern transmitter on the DuoFern network.
Automatic dusk function
The automatic dusk function causes the roller shutters to
close automatically to the lower end point or configured
ventilation position.
Automated solar function
The automated solar function enables brightness-de-
pendent control of your roller shutters. The control
signals for this function are provided by a light sensor
on the DuoFern network.
When the automated solar function is triggered, your
roller shutters will lower to the configured sunshine
position, see page 86.
84
The ventilation position
If you do not want the roller shutters to close fully to the
lower end point, you can use this function to configure
an arbitrary position (e.g. as ventilation position).
The ventilation position must be set in the DuoFern
network
The ventilation position cannot be set via the device
but instead must be set via the DuoFern controller
(HomePilot® or DuoFern manual central operating unit).
To set the ventilation position, please read the
manual of the respective device.
Function with an automatic closing command
When closing automatically, the roller shutters will stop
at the ventilation position, however, they can subse-
quently be closed completely via manual operation.
EN