Anti-Tip Tubes; Seat; Seat Width And Seat Depth Growth - Zippie Simba Gebrauchsanweisung

Anti-Tip Tubes

Sunrise Medical recommends anti-tip tubes for all chairs. When fitting
anti-tip tubes, use a torque of 16 Nm (Fig.5.23)
1. Slotting the anti-tip tubes into the clamp:
a. Press the rear button on the anti-tip tube on the anti-tip tube
adaptor, so that both release pins are drawn inwards.
b. Slot the anti-tip tubes (1) into the anti-tip tube adaptor.
c. Turn the anti-tip tubes downwards until the release pin locks into the
clamp.
d. Fit the second anti-tip tube in the same way.
2. Adjusting the anti-tip tubes:
To achieve the correct ground clearance of approx. 1" to 2" (2.5 cm to
5.0 cm), the anti-tip tubes must be raised or lowered.
Press the anti-tip tube release button, so that both release pins are
drawn inwards. Move the inner tube up or down to slot into the height
holes provided. Release the button. Fit the second anti-tip wheel in
the same way. Both wheels should be at the same height.
DANGER!
If the anti-tip tubes are not fitted, or have been fitted incorrectly, there
is a risk of tipping over and of injury.

Seat

Seat sling
Remove the screws on the left side of the sling.
Adjust the VELCRO® material to increase the tension of the seat
sling. Tighten up the screws again.
If the screws are difficult to fit back in place, try and locate the holes
with a sharp object. Ensure also that the plastic base is in the correct
position before the screws are tightened again, (5.24).

Seat width and seat depth growth

Seat width growth
The seat width can be expanded by one step:
• The screws in the footrest and axle, as well as the two stabilising
bars, must be loosened,
• Back and seat slings must be loosened using the Velcro and set to
the next largest seat width,
• Footrest, axle and the two stabilising bars must be set to the next
largest seat width and then re-tightened.
Seat depth growth
The seat depth can be increased by two steps:
• Two screws must be loosened and the complete part must be
pushed backwards by one or two positions,
• The screws must then be re-tightened.
Simba
Fig. 5.23
Fig. 5.24.
22
1
Rev.5.0