Button Sound - Alde Compact 3010 Betriebsanleitung Und Installationsanleitung

17. Menu Menu
In the "Menu" setting one can activate a number of functions. To activate the
function you must first light up the lower row of functions (see item 11).
To step between the various functions, use the arrow keys.
OFFSET
(Temperature adjustment)
With this function you can calibrate
the temperature on the panel if
you notice that the temperature
(the stabilised room temperature)
does not correspond with the
temperature shown on the panel.
1 Press the button with the arrow
until the Menu symbol flashes.
Press +On.
PUMP 12V/PUMP AU.
The12V pump is used in the PU 12
setting even if 230V is connected.
In the PU AU position, the 230V
pump works, and when 230V
is disconnected, the 12V pump
starts. The PU AU function is
activated in the factory setting.
1 Press the button with the arrow
until the Menu symbol flashes.
Press +On.
SERVICE
With this function one can see
what values* from the heater
are displayed. The values are
updated once per second.
1 Press the button with the arrow
until the Menu symbol flashes.
Press +On.
* The values shown during service are:
FA (revolutions): The speed of the fan divided by 2.
SH (temp): Warm water temperature.
HE (temp): Operating temperature.
OH: If the overheating protection has been tripped On or
alternatively Off.
HS (X): Software version in the heater.
PS (X): Software version on the panel.

Button sound

With this function you can connect
or disconnect the button sound
to the buttons. The button sound
is disconnected in the factory
setting.
1 Press the button with the arrow
until the Menu symbol flashes.
Press +On.
 When OF is displayed, adjust the
temperature displacement with
+/On or -/Off (+/-5°C in intervals of
0.5°C).
blinkar
flashes
 When OF is displayed, step with
the arrow key until PU AU is
displayed. Press +/On and PU 12
is displayed.
blinkar
flashes
 When OF is displayed, step with
the arrow key until SE is displayed.
Press +/On to see the various
values (-/Off can also be used).
blinkar
flashes
I: Amp. Guideline value shown in steps of 0.5 A.
WI: Window breaker on-off.
ES: External start on-off.
10-RS: Heater information, only for ALDE.
 When OF is displayed, step
with the arrow key until Sn is
displayed. Press +/On and the
button sound is connected.
blinkar
flashes
GB
3 Press Store to leave the
OFFSET function.
3 Press -/Off and PU AU is
displayed. Press Store to leave
the pump function.
3 To leave Service, press Store.
blinkar
flashes
3 Press -/Off to disconnect the
button sound. Then press
Store to leave the button sound
function.
blinkar
flashes
blinkar
flashes
blinkar
flashes
11