B) Setup - Reely Free Men Bedienungsanleitung

b) Setup

• T he instructions for the remote control system and charger are included separately. Always follow all
the safety information as well as all other information! Numerous hazards are associated with improper
handling of the battery charger.
• Never wind the aerial cable! This significantly reduces the transmission range. Take care not to damage
the antenna cable. Never attempt to shorten the cable!
• Only use suitable drive batteries for the vehicle. Never power the speed controller with a power adapter,
even for test purposes.
• This vehicle is only suitable for use with a 6-cell NiMH battery (nominal voltage 7.2 V) or a 2-cell LiPo
battery (nominal voltage 7.4 V).
Using a drive battery with more cells may make the speed controller overheat and cause a fire. In ad-
dition, the powertrain may be damaged due to overload (e.g. differential), which will void the warranty/
guarantee!
Warning!
The NiMH battery charger should only be used to charge a NiMH vehicle battery. Attempting to
charge a LiPo battery with the NiMH battery charger may cause a fire or explosion!
A LiPo battery can only be charged with a compatible LiPo battery charger (similarly, NiMH batteries
must be charged with a NiMH charger). If you wish to purchase a LiPo battery for the vehicle, you will
also need to purchase a suitable LiPo battery charger.
Always ensure that you use the correct type of battery charger.
• Always switch on the remote control before connecting the vehicle battery and switching on the speed
controller, otherwise the vehicle may react unexpectedly!
Proceed as follows:
- Before connecting the battery, place the vehicle on a suitable surface so that all wheels can move
freely.
- Switch off the speed controller.
- Switch on the remote control and check that it functions correctly (e.g. the display turns on).
- On the remote control, set the trim for the throttle/brake function to the central position.
- Connect a fully-charged vehicle battery to the speed controller in the correct polarity.
- Turn on the speed controller. Wait for a few seconds until the speed controller has completed a self-
test.
- Check that the vehicle reacts to the remote control commands as expected (steering and throttle)
before removing it from the support and placing the wheels on the ground.
30