Dometic WAECO PerfectCharge BI01 Montage- Und Bedienungsanleitung Seite 21

PerfectCharge BI01
2.3 Safety when installing the device
DANGER!
D
 Never mount the device anywhere where there is a risk of gas
or dust explosion.
NOTICE!
A
 Do not expose the device to a heat source (such as direct sun-
light or heating). Avoid additional heating of the device in this
way.
 Set up the device in a dry location where it is protected against
splashing water.
2.4 Safety when connecting the device electronically
DANGER! Danger of electrocution
D
 For connection on boats:
If electrical devices are incorrectly connected on boats, corro-
sion damage to the boat might occur. Have the device con-
nected by a specialist (marine) electrician.
 If you are working on electrical systems, ensure that there is
somebody close at hand who can help you in emergencies.
WARNING!
!
 Make sure that the lead has a sufficient cross-section.
 Lay the cables so that they cannot be damaged by the doors or
the bonnet.
Crushed cables can lead to serious injury.
CAUTION!
!
 Lay the cables so that they cannot be tripped over or damaged.
NOTICE!
A
 Use ductwork or cable ducts if it is necessary to lay cables
through metal panels or other panels with sharp edges.
 Do not lay the cable so that it is loose or heavily kinked.
 Fasten the cables securely.
 Do not pull on the cables.
EN
General safety instructions
21