Replacing The Lamp; Closing The Door; Installation - Electrolux ERN2012BOW Benutzerinformation

If the advice does not lead to
the desired result, call the
nearest Authorized Service
Centre.

8.2 Replacing the lamp

The appliance is equipped
with a longlife LED interior
light.
CAUTION!
Disconnect the plug from the
mains socket.
1. At the same time, with the fingers
expand up and down the transparent
cover and unhook it in the direction of
the arrows.

9. INSTALLATION

WARNING!
Refer to Safety chapters.
9.1 Location
Refer to the assembly
instructions for the
installation.
To ensure best performance, install the
appliance well away from sources of heat
such as radiators, boilers, direct sunlight
etc. Make sure that air can circulate
freely around the back of the cabinet.
1
2
1
2. Replace the lamp with one of the
same power and shape, specifically
designed for household appliances.
The maximum power is shown on the
light bulb cover.
3. Reassemble the lamp cover.
4. Connect the plug to the mains
socket.
5. Open the door.
Make sure that the light comes on.

8.3 Closing the door

1. Clean the door gaskets.
2. If necessary, adjust the door. Refer
to "Installation".
3. If necessary, replace the defective
door gaskets. Contact the Authorised
Service Centre.
9.2 Positioning
This appliance can be installed in a dry,
well ventilated indoor where the ambient
temperature corresponds to the climate
class indicated on the rating plate of the
appliance:
Climate Ambient temperature
class
SN +10°C to + 32°C
N +16°C to + 32°C
ST +16°C to + 38°C
T +16°C to + 43°C
ENGLISH 27