Cleaning And Maintenance - Ariete EVOLUTION 2.0 Anleitung

E N
sETTING THE CLEANING PROGRAMME
- Press the "CLEAN" button to set the Robot to "pause".
- Press the "PLAN" button to enter the programming mode.
- Press the "SPOT" and "HOME" buttons together to set the day, from the number "1" which represents
Monday, through to "7", which is Sunday.
- Press "CLEAN" to confirm and quit or "PLAN" to set the time for daily cleaning.
- Press the "SPOT" and "HOME" buttons together to set the hours: then press "PLAN" to confirm and
pass on to the minutes or press "CLEAN" to confirm and return to the days setting.
- Press the "SPOT" and "HOME" buttons together to set the minutes, then press "CLEAN" to confirm
and quit, returning to days, or press "PLAN" to confirm and return to the hours.
Important!
A sound signal will be emitted to show that the time has been saved. If no sound is
heard, re-enter the settings and save again.
At the selected time, the Robot will move from its charging station to start the cleaning cycle and then
return to the station when the cleaning is complete or if the batteries are almost flat. Once it has begun
to return to the station, the Robot may take up to 30 minutes to intercept the signal and reposition itself
on the "Home Base".

CLEANING AND MAINTENANCE

For the correct maintenance of the Robot, follow the rules below:
CLEAN THE SIDE BRUSHES ON A
REGULAR BASIS AND REPLACE THEM IF
DAMAGED.
- Remove the screw in the centre of each
brush support.
- Remove the brushes and replace them,
making sure that the marks "L" (left) and
"R" (right) meet with the same marks on the
appliance base.
- 32 -