Ariete EVOLUTION 2.0 Anleitung Seite 33

Important!
The Robot cannot return to the charging station if the station is not connected to the
mains power; in this case, the suction function will be reduced until it runs out and the
Robot will switch off.
Important!
During the return to the charging station, the suction function is suspended and therefo-
re, the noise level will be lower.
DURING THE CLEANING CYCLE
The coverage time for a room may vary according to floor type and to the number of obstructions the
Robot encounters as well as the possible differences in height on the floor.
Thanks to its front anti-collision sensors, the Robot is able to intercept surfaces (walls, furniture...) avoid-
ing collisions with them. However, if the obstruction consists of corners or tubular parts of furnishings,
then a gentle impact may be possible. Special anti-fall sensors on its base mean that the Robot is able
to recognise differences in height and therefore, to avoid falling from tops or stairs.
The Robot is also able to overcome differences in level such as thresholds or rugs and to move away
from obstacles (pipes, floor lamps, etc.) of no higher than 1 cm.
Important!
When cleaning carpets or rugs, do not allow the Robot to come into contact with fringes
and do not clean shag pile carpets, as the fibres and fringes may become caught up around
the rotary brushes.
UsING THE RObOT WHERE THERE Is A GOOD DEAL OF
EXPOsURE TO sUNLIGHT
When using the robot in rooms with a great deal of exposure to sunlight, we recommend closing blinds
or curtains to reduce this and to remove the problems that could incorrectly change the direction and
route of the appliance.
sETTING THE DATE AND TIME
- Hold down the "PLAN" button for 3 seconds to enter the clock setting mode.
- Press the "SPOT" and "HOME" buttons together to set the hours: then press "PLAN" to confirm and
pass on to the minutes.
- Press the "SPOT" and "HOME" buttons together to set the minutes, then press "CLEAN" to confirm
and pass onto setting the day.
- Press the "SPOT" and "HOME" buttons together to set the day, from the number "1" which represents
Monday, through to "7", which is Sunday.
- Press "CLEAN" to exit and quit.
- To delete the time, set it to 00:00 and save.
- 31 -
EN