Ariete EVOLUTION 2.0 Anleitung Seite 32

E N
The different cleaning modes can be set from the touch screen:
1) AUTOMATIC cleaning:
Pressing the "CLEAN" button will start the Robot
cleaning the room automatically and changing
its route according to the obstructions on the
floor, applying alternately:
- spiral movements
- linear perimeter movements
- linear diagonal movements
- automatic "SPOT cleaning": faster spiral
movements with greater suction when the
dust detection sensors find a particularly
dirty area. This function is interrupted
automatically when the area has been
cleaned or it can be stopped by pressing
the "CLEAN" button.
Important!
For the best cleaning results and to make sure that the Robot can cover the entire surfa-
ce of the room without leaving any area uncovered and in the shortest possible amount
of time, it is necessary to remove as many obstructions from the floor as possible.
Important!
To prevent the Robot from getting stuck, remove or lift any wires and power cords that
could become wrapped around the rotary brushes and cause items to fall from furniture
or break or damage the Robot.
2) SPOT cleaning:
To focus cleaning on a smaller area, it is possible to use the "SPOT" button on the Robot to use the Spot
cleaning function (for the operation mode, see the instructions above).
3) Return to the charging station:
Using the "HOME" button on the Robot, it is possible to make it return to the base when necessary.
- the Robot must be able to intercept the IR signal from the charging station which must therefore be in
the same room as is being cleaned;
- if the Robot is not able to return to the base at the first attempt, it will continue to try until it is correctly
positioned.
Important!
If the Robot is unable to return to the charging station at its first attempt, it will continue to try
to do so until it is correctly positioned.
- 30 -
Home
Base