Standard Installation - STIEBEL ELTRON DEL 18 Plus Bedienung Und Installation

INsTALLATIoN
Installation

10.1 Standard installation

Opening the appliance
f Open the appliance by holding the fascia at the side and pull- f
ing forwards away from the appliance cover. Undo the screw.
Pivot open the appliance cover.
f Remove the back panel by pressing the two locking tabs and f
pulling the lower section of the back panel forwards.
Preparing the power cable on unfinished walls, for connection
from below
160
30
1 Cable entry installation aid
f Prepare the power cable. f
Fitting the wall mounting bracket
f Mark out the holes for drilling using the installation tem- f
plate. If the appliance is to be installed on finished walls, also
mark out the fixing hole in the lower section of the template.
f Drill the holes and secure the wall mounting bracket at 2 f
points using suitable fixing materials (screws and rawl plugs
are not part of the standard delivery).
f Fit the wall mounting bracket. f
30 | DEL Plus
Installing the twin connector
f Seal and insert the twin connectors.
Making the water connection
1 DHW with tee
2 Gasket
3 Cold water with 3-way ball shut-off valve
4 Strainer
5 Plastic profile washer
f Secure the tee and 3-way ball shut-off valve, each with a flat
1
Installing the appliance
1 Cable entry installation aid
2 Cable grommet
Use the installation aid for easier wiring access through the cable
grommet (see plastic parts set supplied).
f Remove the cable grommet from the back panel.
f Pull the cable grommet over the cable sheath of the power
Material losses
!
Carry out all water connection and installation work in
accordance with regulations.
f
2
2
1
3
24
5 Nm
5 4
f
gasket, to the twin connector.
Material losses
!
The strainer must be fitted for the appliance to function.
f When replacing an appliance, check whether the f
strainer is installed.
Note
If you are installing the appliance with flexible pipe con-
nections, also secure the back panel with a screw.
f
f
cable. For large cable cross-sections, enlarge the hole in the
cable grommet if necessary.
1
2
www.stiebel-eltron.com