Installation; Standard Installation - STIEBEL ELTRON DHB 18 STi Bedienung Und Installation

INSTALLATIoN

Installation
10. Installation

Standard installation

- Electrical connection from below on unfinished walls
- Water connection on unfinished walls
For further installation options, see chapter "Installation /
Installation options":
- Electrical connection from above on unfinished walls
- Electrical connection on finished walls
- Large conductor cross-section for electrical connection from
below
- Connecting a load shedding relay
- Water installation on finished walls
- Water installation on finished walls with brazing / compres-
sion fitting
- Water installation on finished walls; fitting the appliance
cover
- Installation of lower back panel with threaded fittings on fin-
ished walls
- Wall mounting bracket when replacing an appliance
- Installation with offset tiles
- Pivoting appliance cover
10.1 Standard installation
Opening the appliance
f Open the appliance by pulling the flap downwards, undo the f
screw and lift up the appliance cover.
f Remove the back panel by pressing the two locking hooks f
and pulling the lower section of the back panel forwards.
www.stiebel-eltron.com
Preparing the power cable
160
30
1 Installation aid
f Prepare the power cable. f
Fitting the wall mounting bracket
f Mark out the holes for drilling using the installation plate. f
If the appliance is to be installed with water connections on
finished walls, also mark out a fixing hole in the lower part
of the template.
f Drill the holes and secure the wall mounting bracket with f
2 screws and 2 rawl plugs (screws and rawl plugs are not
part of the standard delivery).
f Fit the wall mounting bracket. f
Making the water connection
Material losses
!
Carry out all water connection and installation work in
accordance with regulations.
f Seal and insert the twin connectors. f
1
DHB STi | 23