Herunterladen Inhalt Inhalt Diese Seite drucken

Information; Safety Information - BMW i Wallbox Bedienungsanleitung

Vorschau ausblenden Andere Handbücher für i Wallbox:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 1

INFORMATION

Safety information

WARNING
Electrical danger.
The Wallbox must be installed, commissioned and maintained by suitably trained, qualified
and authorised electricians
standards and installation regulations. See installation manual for details.
Electrical danger / Danger of fire.
Never use defective, worn or dirty charging cable plugs.
The owner (end customer) must ensure that the Wallbox is only operated if it is in perfect
condition.
The Wallbox must be checked at regular intervals for defects on the charging cable plug
(including charging cable) and for signs of damage to the housing (visual inspection).
A damaged Wallbox must be switched off and replaced without delay.
Repair work to the Wallbox is not permitted and may only be completed by the
manufacturer or a trained expert (Wallbox replacement).
Do not make any unauthorised changes or modifications to the Wallbox.
Do not remove any identifiers such as safety symbols, warning instructions, rating plates,
labels or cable markings.
The Wallbox does not have its own mains switch. The residual-current-operated circuit
breaker (RCCB) and circuit breaker on the building insulation is used as a mains isolation
device.
Do not use an extension cable for connecting an electric or plug-in hybrid vehicle to the
Wallbox.
Only connect electric or plug-in hybrid vehicles or the chargers. Do not connect any other
consumers (electric tools, etc.). 
Persons who, as a result of their training, skills and experience and their knowledge of the relevant
(1)
standards, can assess the work assigned to them and identify possible dangers.
CAUTION
Danger of damage.
Never clean the Wallbox using a jet of water (hosepipe, pressure washer, etc.).
Ensure that the Wallbox is not damaged by incorrect handling (housing cover, internal parts,
etc.).
On outdoor installations, do not open the termination panel cover when it is raining.
Only pull the charging cable out of the connector using the charging cable plug, not the
cable.
Ensure that the charging cable is not mechanically damaged (kinked, jammed or run over)
and that the contact area does not come into contact with heat sources, dirt or water. 
26
who bear full responsibility for compliance with current
(1)

Werbung

Inhaltsverzeichnis

Fehlerbehebung

loading

Inhaltsverzeichnis