Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
RB-03 Stereo Power Amplifier
Troubleshooting
Most difficulties in audio systems are the re-
sult of poor or wrong connections, or improper
control settings. If you encounter problems,
isolate the area of the difficulty, check the con-
trol settings, determine the cause of the fault
and make the necessary changes. If you are
unable to get sound from the RB-03, refer to
the suggestions for the following conditions:
Front Panel Power Indicator Is
Not Lit
No main power to the RB-03. Check the front
panel power switch. Make sure that it is set
to the on position. Check AC power connec-
tions at the amplifier and the AC outlet.
Fuse Replacement
If everything checks out correctly and you still
cannot get the amplifier to turn on, the inter-
nal power fuse may have blown. If you be-
lieve this has happened, contact your autho-
rized Rotel dealer for information on where
to take your amplifier to get the fuse replaced.
No Sound
If the amp is getting AC power, but is producing
no sound, check all of your connections and
control settings on associated components.
Specifications
Continuous Power Output
(20-20 kHz, < 0.03%, 8 ohms)
Bridged Mono Power Output
(20-20 kHz, < 0.1%, 4 ohms)
Total Harmonic Distortion (20Hz-20kHz, 8 ohms)
Intermodulation Distortion (60 Hz : 7 kHz, 4:1)
Frequency Response ( ± 1dB)
Damping Factor (20-20,000 Hz, 8 ohms)
Speaker Impedance (Normal mode)
Signal to Noise Ratio (IHF A network)
Input Impedance/Sensitivity
Power Requirements
USA Version
European Version
Power Consumption
Dimensions (W x H x D)
17
1
/
x 3
5
/
x 13
3
/
ins.
8
8
16
Panel Height
Weight (net)
All specifications are accurate at the time of printing.
Rotel reserves the right to make improvements without notice.
8
70 watts/ch
180 watts
(200 watts at 1kHz)
< 0.03%
< 0.03%
10Hz-100kHz
500
4 ohms minimum
116 dB
33 k Ohms/1.0 volt
115 Volts, 60 Hz
230 Volts, 50 Hz
250 Watts
435 x 92 x 334 mm
5
80 mm / 2
/
"
32
7.5 kg, 16.54 lb.
Werbung
Inhaltsverzeichnis
Fehlerbehebung
