SPORTSTECH CX625 Benutzerhandbuch Seite 54

7. Handlebar and Computer Installation
Remove two M8x15 Bolts (19) and two Ø8xØ16 Curve Washers (20) and two PVC washer
Ø10xØ20(21) from the Front Post (2).
Insert the Hand Pulse Sensor Wires (14) from the Handlebar (11) into the hole on the Front Post (2)
and then pull them out from the top end of the Front Post (2).
Attach the Handlebar (11) onto the Front Post (2) with two M8x15 Bolts (19) and two Ø8xØ16
Curve Washers (20) and two PVC washer Ø10xØ20(21) that were removed.
Remove four M5x10 Bolts (17) from the back of the Computer (16).
Connect the Sensor Wire I (18) and Hand Pulse Sensor Wires (14) to the wires that come from the
Computer (16) and then attach the Computer (16) onto the top end of the Front Post (2) with four
M5x10 Bolts (17) that were removed.
54