Configuring The Remote Access; Changing The Password; Troubleshooting - CitrinSolar CS WebBox2 Handbuch

7.17 Configuring the remote access
AttENtION! third-party access!
When the default remote access password is not changed, third
parties may gain unauthorised access to the controller connected.
Î Do change the remote access password, note it down
and keep it in a suitable place.
The remote access password is required whenever a controller connected to the
Communication module is to be accessed via the Parameterisation Tool.
In order to change the remote access password, proceed as follows:
Î In the Configuration main menu, select the Remote access submenu.
Î On the Bus access over local network tab, in the Local network access
enabled dropdown menu, select Yes.
Î Enter the new password into the Bus password field.
The factory setting for the remote access password is vbus.
Î On the Remote access over Internet tab, in the Remote access over
the Web portal dropdown menu, select Yes.
Î Click Save configuration.
The default setting for the Bus access and the Web portal is Yes.

7.18 Changing the password

In order to change the user password, proceed as follows:
Î In the Configuration main menu, select the Users submenu.
Î Enter the current password into the Password field.
The default password can be found at the back of the housing (Web-interface).
Î Enter the new password into the New password field.
Î Enter the new password into the Confirm new password field.
Î Click Change your password.
36
8

troubleshooting

User password not available
Problem Solution
The user password is When the user password is not available, the Commu-
not available. nication module has to be reset to its factory settings in
order to regain access to the web interface. The pass-
word can be found at the back of the housing (Web-
interface).
Note
If the Communication module is reset to its factory settings, the configu-
ration previously made will be lost.