Configuration For Vbus.net - CitrinSolar CS WebBox2 Handbuch

5.2 Configuration for VBus.net
In most systems, the Communication module can be connected to VBus.net with-
out any configuration. For further information, see chap. 7.14 on page 34.
In order to access the Communication module over the VBus.net server, proceed
as follows:
Î Note down the alphanumeric 8-10-digit code (Token) indicated on the back of
the housing.
Î Enter VBus.net into the address bar of the browser and click Sign up.
Î Wait for the confirmation e-mail to arrive.
Î Click Add new device.
Î Enter the alphanumeric 8-10-digit code (Token).
5.2.1 WLAN connection to VBus.net (internet access)
The WLAN connection to VBus.net can be established either with the WPS func-
tion or over the Web interface. For this purpose, make sure that the WLAN coun-
try setting is correct, see chap. 7.14 on page 34.
With the WPS function, the Communication module can be connected to the
router by pressing a single button.
WLAN-LED
30
Î In order to connect the Communication module to the router via WPS, keep
The WLAN LED will flash.
Î Press the WPS button of the router.
The connection will be established.
The WPS function can also be activated via the Web interface, see chap. 7.15 on
page 35.
For further information, see:
chap. 4.2 Button on page 27
chap. 6 Finding the Communication module in the network on page 31
chap. 7.12 Network configuration on page 34
5.2.2 LAN connection to VBus.net
The Communication module can be connected to VBus.net via LAN. For further
information, see:
chap. 3.3 (W)LAN connection on page 26
chap. 6 Finding the Communication module in the network on page 31
chap. 7.12 Network configuration on page 34
chap. 7.17 Configuring the remote access on page 36
Button
Note
Using WPS for establishing the connection can lead to security vulner-
abilities.
the button pressed for 5 s.
Note
Pay attention to the router documentation.
Note
The WLAN connection can also be established via the Web interface, also
described in chap. 7.15 on page 35.