LENCO L-90X Bedienungsanleitung Seite 8

Playing records
Switch the main power switch on the backside of the turntable to the "on" position. Open the dust
cover and place the record on the platter. If you play a single, do not forget to place the single puck
first.
▪ Set the correct RPM speed
▪ Remove the needle protection cover from the stylus
▪ Unlock the tone arm on the armrest
▪ Bring the tone arm to the record, the platter now starts rotating
▪ Carefully place the tone arm on the record. Do not forget to lower the arm lever
If you want to interrupt a record during playing, raise the arm lever. Alternatively, return it to the
armrest to stop the record playing. When a record has come to its end, the platter stops rotating*.
* Auto-stop should be on.
Connect the turntable to a computer for the first time
▪ As this turntable is plug-and-play, no drivers are needed.
▪ Before you connect the turntable to a computer, unplug it from your mixer or
Hi-Fi system.
▪ The included software is a third party application and therefore Lenco does not
handle any questions or problems regarding the software.
1. Switch the computer on
2. Connect the turntable to an AC wall outlet
3. Place the main power switch on the back side of the turntable in the "on" position
4. If the computer is booted, connect the turntable. The computer will now install the drivers.
5. After the drivers are installed, you must now install the Audacity software.
▪ For windows users; download the newest software via
▪ For MAC users; download the newest software via
Important: Make sure that your computer recognizes the turntable as a recording device. Especially
Windows has the tendency to set the turntable default as a playing device. If the turntable is set as
playing device, Audacity cannot record your records.
http://www.audacityteam.org
http://www.audacityteam.org
8