Cembre B500-KV Bedienungsanleitung Seite 7

To replace the battery, remove it by pressing the release button (7) (Ref. to Fig. 1),
then insert the new battery, sliding it into the guides until it locks.
The display shows the operational parameters of the tool; to customise them proceed
as described in § 2.7.
Select the appropriate die set for the connector.
Open the latch (41) and release the upper die holder (42).
Insert one die into the upper die holder (42) until locked by the ball (83) and
one die into the lower die support (49) until locked by the spring clips (62).
Close the head.
Insert the conductor into the connector (Ref. to Fig. 3).
Position the connector between the dies and ensure the correct location of the crimp (Ref. to
Fig. 4).
NOTE
: when more compression is
required, proceed according to the
sequence and direction indicated
in the gure.
Ensure that the latch and the upper die holder are fully secured, otherwise damage may
occur during tool operation.
2.2) Die advancement
Press operating button (4) (Ref. to Fig. 4) to activate the motor-pump and advance the lower
die.
To halt the advancement, release operating button (4) and the motor will cut out.
Make sure the dies are exactly positioned on the desired crimp point otherwise
re-open dies following instructions as per § 2.4 and reposition the connector.
2.3) Compression
By keeping operating button (4) pressed, the motor continues to operate: the ram
will gradually move forward until the two dies touch.
The motor will stop automatically when the set pressure has been reached.
To perform proper compression, press and hold the operating button (4) until the motor
stops automatically.
7
terminal
2 3
1
3
1 2
1
2
3
connector