Cembre B500-KV Bedienungsanleitung Seite 11

3 SEC.
The capacitive menu selection button may not work if touched using
objects or when wearing gloves, therefore always operate it using a bare nger.
4.2) SELECTION SCREENS:
of the tool can be changed by operating the touch button:
Enabling/disabling the LED Worklights
LED
ON
LED
OFF
Return to original factory settings / rmware version
When the 'RESET' screen is displayed, return the tool to its factory setting by operating the touch
button for at least 3 seconds; a beep will con rm the setting.
RESET The RESET screen also shows the rmware version of the circuit board.
SW:S1J41AH
4.3) WARNINGS:
these appear during operation and notify the operator of the status
of the tool:
LOW BATTERY: replace the battery.
BATTERY
NOTE: when the battery Vage falls below a minimum safety threshold, the tool
will not start; although it is still possible to end the work cycle in progress.
BATTERY TEMPERATURE HIGH: remove the battery and wait until it cools
BATTERY
down.
NO. OF CYCLES TO MAINTENANCE REACHED:
20001
the tool continues to work however, it is recommended that it is sent to Cembre
for a complete overhaul (see § 5).
NOTE: this message, together with a beep, will reappear when the tool has been
idle for 30 seconds.
RESET
11
To make a selected screen operational and appear at each start-up of the
tool, operate the touch button for at least 3 seconds; a continuous beep
will con rm the setting.
control parameters that cannot be set as automatic upon start-up
(factory setting LED ON)
When the screen is displayed,
touch the button for at least
3 seconds to deactivate or re-
LED
activate operation of the LED
OFF
Worklights during tool use; a
continuous beep will con rm
LED
the setting.
ON