Cembre B500-KV Bedienungsanleitung Seite 6

WARNING
Do not use the tool for purposes other than those intended by Cembre.
The operator should concentrate on the work being performed and be careful to maintain
a balanced working position.
The tool is provided with additional external coatings to protect the operator and tool
against accidental brush contact with energised conductors.
Proper training techniques and practices should always be adhered to when working around
energised conductors.
Always consult your company's work rules and methods to select suitable tooling, rubber
insulated gloves, shrouding and other protective equipment.
Under no circumstances should operatives rely solely on the insulating properties of the
tools alone when working around energised conductors.
Prior to use please ensure the tool and speci cally the insulating protection are not
damaged.
The tool is unsuitable for continuous use and should be allowed to cool down following
uninterrupted, successive crimping operations; for instance, having exhausted a fully
charged battery in one session, delay battery replacement for a few minutes.
Protect the tool from rain and moisture. Water will damage the tool and battery.
Electro-hydraulic tools should not be operated in pouring rain.
2. INSTRUCTIONS FOR USE
IMPORTANT: In order to avoid damaging the tool, do not operate it at maximum pres-
sure, without dies inserted in the head.
When introducing or changing dies, the battery must rst be removed from the tool.
The part reference includes the following (Ref. to Fig. 7 page 45):
Hydraulic crimping tool.
Li-Ion rechargeable battery (2 pcs).
Battery charger (model depends on the tool version).
Shoulder strap.
Plastic carrying case.
USB cable (Ref. to § 5)
2.1) Preparation
The tool can be easily carried using either the handle or the shoulder strap attached to ring (10)
(Ref. to Fig. 6).
Before starting any work, check the battery charge (Ref. to § 2.8) and recharge
if necessary, following the instructions in the battery charger user manual.
6