Electrolux ERN3001FOW Benutzerinformation Seite 12

12 www.electrolux.com
Problem
There is too much frost
and ice.
The compressor does not
start immediately after
pressing the FastFreeze,
or after changing the tem‐
perature.
Water flows on the rear
plate of the refrigerator.
Water flows inside the re‐
frigerator.
Water flows on the floor.
Temperature cannot be
set.
The temperature in the ap‐
pliance is too low/too high.
Possible cause
Food products placed in
the appliance were too
warm.
The FastFreeze is
switched on.
The door is not closed
correctly or the gasket is
deformed/dirty.
The water drainage plug
is not correctly posi‐
tioned.
Food products are not
wrapped properly.
Temperature is set incor‐
rectly.
This is normal, no error
has occurred.
During the automatic de‐
frosting process, frost
melts on the rear plate.
The water outlet is clog‐
ged.
Food products prevent
that water flows into the
water collector.
The melting water outlet
is not connected to the
evaporative tray above
the compressor.
The FastFreeze or Shop‐
ping mode is switched
on.
The temperature regula‐
tor is not set correctly.
The door is not closed
correctly.
Solution
Allow food products to cool
to room temperature before
storing.
Refer to "FastFreeze mode".
Refer to "Closing the door".
Position the water drainage
plug in the correct way.
Wrap the food products bet‐
ter.
Refer to "Operation" .
The compressor starts after
a period of time.
This is correct.
Clean the water outlet.
Make sure that food prod‐
ucts do not touch the rear
plate.
Attach the melting water out‐
let to the evaporative tray.
Switch off FastFreeze or
Shopping manually, or wait
until the function resets auto‐
matically to set the tempera‐
ture. Refer to "FastFreeze or
Shopping mode".
Set a higher/lower tempera‐
ture.
Refer to "Closing the door".