Installation In Metal Doors - Sure Petcare SureFlap Gebrauchsanweisung

7.4 Installation in metal doors

The presence of a metal plate in a door can influence the performance of the
SureFlap Microchip Pet Door, reducing the range of the microchip reader. This includes the
following:
• Metal skin doors
• Security doors
• Metal garage doors
• UPVC coated metal doors
For most situations you will not notice anything, as the read range will still be sufficient for the
majority of microchips and collar tags. However, if you experience intermittent operation or
failure to open for your pet, first check for the presence of a metal plate in the door. Note that
UPVC coated metal doors often look the same as standard UPVC doors and you may need
to look carefully where the panel has been cut. If a metal plate or thin metal foil is confirmed,
follow the instructions below for improved read range.
If there is metal present you will need to cut a larger hole in your door – leaving a gap of
2-3cm (1") between the tunnel of the
around the outer edge of the back frame as a size guide as shown in figure 18. Now mark
your cutting line 1cm (3/8") inside the line you have traced around the back frame, leaving
the screw holes in place as shown in figure 19. Cut this hole and reinstall your
Microchip Pet Door following the instructions in section 7.2.
If you still experience intermittent operation you will need to increase the size of the hole
again, in this case you will require the mounting adaptor shown in Figure 10 (Product Code:
GMA101). For
www.surepetcare.com.
First trace around the circumference of the mounting adaptor as a guide. Now mark a
circle approximately 2cm (1") inside the line from the mounting adaptor, again leaving
the indentations for the screw holes. Cut this hole and then reinstall the pet door again,
following the instructions in section 7.3. This will extend the read range further and should
resolve any issues with mounting in a metal door.
If you have followed the steps above and are still experiencing performance issues please
follow the steps in the troubleshooting section. If all other troubleshooting has been carried
out without finding the source of the problem please contact
for further assistance.
Figure 18
details of where
SureFlap and the metal in your door. To begin with trace
to purchase
13
this adaptor see
Sure Petcare
Figure 19
SureFlap
our website
customer service