Fitting Your Cat Flap In A Wood Or Plastic Door - Sure Petcare DualScan Schnellstartanleitung

PETS: To ensure your pet's safety, do not use this product if parts are missing, damaged or
worn. Sure Petcare recommends the Cat Flap is used with your pet's implanted microchip,
however it may also be operated using the Sure Petcare RFID Collar Tag. If using a collar tag,
it must be used with a safety collar which incorporates a breakaway buckle. Sure Petcare
cannot accept liability for any injury or death caused by a pet's collar.
INSTALLATION: Installing in a metal door or wall?
You will need to download the full user instructions at surepetcare.com/pdf
The steps in this printed manual are not suitable for installations into metal
doors or walls. Do not install the Cat Flap in a fire door, it will render it unfit
for purpose.
Before installing, you should consider any potential hazards present inside or outside the
intended location, as well as the impact subsequent modifications to your property may
have on the use of your Cat Flap. If you have any doubts concerning the installation, it is
recommended you consult a professional. Only use approved Sure Petcare accessories and
spare parts with your DSCF.

Fitting your cat flap in a wood or plastic door

For more information about installing in metal doors, glass, or brick walls, please
download a full manual from surepetcare.com/pdf
Ruler
Spirit level
Blu Tack
Ensure your cat(s) can pass through the flap before fitting.
Flap opening dimensions = 142 x 120mm (5 9/16'' x 4 3/4'')
1
2
When using power tools, follow all safety instructions provided with the product.
3
Sharp pencil
Electric jigsaw
Protective eye-wear
To ensure your cat has unhindered access, first measure the height
from their tummy to the floor. This measurement is the distance
from the floor to the bottom edge of the hole you need to cut. Mark
this on your door.
Stick the external frame to the door aligning the bottom edge of the
hole with the measured mark. Use a spirit level to ensure the frame
is level, then run a sharp pencil around the inside edge of the frame.
Electric drill with a 6mm (1/4'') drill bit
Cross head screwdriver
The screws and caps provided