Memory Wipe; Use As A Non-Selective Pet Door; Custom Modes - Sure Petcare SureFlap Gebrauchsanweisung

12. Memory Wipe

It is very unlikely that you will need to wipe a pet's ID code from the pet door's memory. Up
to 32 different codes can be stored in memory, and if more additional codes are learnt these
simply replace the earliest ones stored. However, in the unlikely circumstance that you need to
wipe the memory (e.g. you accidentally programme for a neighbour's pet!), follow the process
below.
1. Press and hold the memory button (
2. When the memory is wiped, the locks will open and close once.
3. At this point the memory is clear and the pet door can re-learn your pet(s) microchip
numbers, as required. See section 6. Wiping the memory also wipes any custom modes
you may have selected (see section 14).

13. Use As A Non-Selective Pet door

In the event that you want to use your
selective pet door, follow the instructions in custom modes (section 14) and choose custom
mode 1.
This mode may be useful if you have purchased the
your pet has been microchipped or while your pet is getting used to the presence of its new
pet door (see troubleshooting guide). As an alternative, the
available if your pet is not microchipped.

14. Custom Modes

The SureFlap Microchip Pet Door has a number of custom modes to accommodate
less common requirements. This section shows you how to enter and exit these custom
modes and what some are used for. Note: our customer service department may also make
use of other modes in order to assist in diagnosing or fixing problems.
To set a custom mode follow the steps below:
Press and hold the (
button is recessed. The custom mode display will appear on the LCD screen. This display
shows the most recently stored custom mode, or Custom Mode 0 (C00) if none are already in
use.
To select a mode use buttons one (
the desired custom mode. Press button 5 (
be stored into memory until cleared (even if the batteries are removed). Once stored the
indicator light will flash green for a couple of seconds. Note that you can exit the
custom mode menu at any time by pressing the (
will be stored.
To clear all custom modes then select custom mode 0 (C00) or completely wipe the pet door
memory (see section 12).
SureFlap
) button for 10 seconds. You will need to use a pen or pencil as the
) and two (
) for at least 10 seconds.
Microchip Pet Door as a standard non-
SureFlap
Sure Petcare
) to cycle through the options and select
) to choose the custom mode, which will then
) button, and no additional custom mode
21
Microchip Pet Door before
RFID Collar Tag is