Special Cleaning Of Tube And Filter; Tube Blow-Dry Function; Assembling The Pump - NUK BP7 First Choice+ Bedienungsanleitung

• Incorrect treatment can damage the
parts.
• Before using again, allow the sterilised
parts to cool and dry completely before
reassembling.
• Only use water
sterilisation:
1. Use a NUK Steam Steriliser, following the
operating instructions of the device.
Alternatively,
2. sterilise the parts in boiling water for 5
minutes.
Ensure there is sufficient water in the pan
to avoid damage.
Alternatively,
3. use a NUK
Microwave
sterilisation in your microwave oven.
• Only use the NUK Micro Express Plus
Microwave
microwave sterilisation.
operating instructions of the device.
5.3 Special cleaning of tube
and filter
1. If milk enters the tube 4, switch the
device off immediately.
2. Dismantle the device as shown in figure B,
proceeding in reverse from 7 to 1.
3. Remove the filter 6 (see figure C).
4. Clean the following parts with lukewarm
water and a little washing-up liquid and/
or NUK Rinsing Agent:
– rinse filter 6 ;
– flush tube 4 with tube connector plug 7.
1. Assemble the device as shown in figure B.
Note: Make sure the silicone cushion 10 fits
snugly in the breast shield 9 and the lip
valve 11 is properly mounted, as the pump
can otherwise draw in air, which will prevent it
from working properly.
and steam
Micro Express
Steam Steriliser
Steam Steriliser
Follow

6 Assembling the pump

5. Reassemble according to figure C or B in
reverse order and then use the blow-dry
function
function" on page 29) of the device to dry
the tube 4 and the tube connector plug 7.
for Note: Since the filter 6 would be a virtually
impermeable barrier while wet or damp, it
would inhibit the blow-dry function and the
pump suction. Insert the dry replacement
filter instead. Leave the freshly cleaned and
rinsed damp filter to air-dry for at least
4 hours.

5.4 Tube blow-dry function

1. Assemble the device as shown in figure B.
Do not insert a filter that is still damp, but
use a dry replacement filter instead.
Plus
for
2. To start the blow-dry function press the
master power switch
simultaneously touch the buttons
and
for
the
The blow-dry function runs for 5 minutes.
3. Check that the tube is completely dry (no
droplets visible inside), before starting
the next pumping session.
If the tube is not yet completely dry, start
the blow-dry function again.
You can pause the blow-dry function by
touching the Pause button
continue it later by touching the Pause
button
4. To stop the blow-dry function, switch the
pump unit off by pressing the master
power switch
29
(see "5.4 Tube
25.
25 again.
26.
blow-dry
26 and then
22
25 and