Cleaning And Sterilising; Cleaning (Figure A In Reverse Order); Sterilising - NUK BP7 First Choice+ Bedienungsanleitung

Warning! Hygiene is the top priority
when handling breast milk and all
parts which come into contact with
it. You should therefore only use
a pump
sterilised.
Wash your hands thoroughly
before using the breast pump.
The following parts come into contact with
your breast milk and must be immediately
cleaned and sterilised after every use
(see "5.1 Cleaning (Figure A in reverse
order)" on page 28 and "5.2 Sterilising" on
page 28):
9 Breast shield
10 Silicone cushion
11 Lip valve
12 Breast milk container
15 Feeding teat
16 Screw ring
17 Protective cap
18 Sealing disc
The following parts must never be cleaned
and sterilised with water:
3 Pump unit
13 Mains adapter
14 USB cable
5.1 Cleaning
Warning! To avoid the risk of elec-
tric shock:
Unplug mains adapter 13 from the
wall socket before cleaning.
Caution! To avoid damage, carefully clean
the lip valve 11. We recommend just rinsing
off the lip valve and boiling it to sterilise.
Cleaning implements may lead to damage.
1. Dismantle the device as shown in figure B,
proceeding in reverse from 7 to 1.
Warning! Never submerge the
pump unit 3, the mains adapter 13,
or the USB cable 14 in water, as
this will damage the electrical
contacts.

5 Cleaning and Sterilising

that is clean
(Figure A in reverse order)
2. Clean the following parts with warm
water and a little washing-up liquid (or
NUK Rinsing Agent).
Then rinse the parts in running water:
and
9 Breast shield
10 Silicone cushion
11 Lip valve
12 Breast milk container
15 Feeding teat
16 Screw ring
17 Protective cap
18 Sealing disc
Caution!
in a dishwasher – dishwasher detergents
can cause product damage.
Note: When rinsing with dishes (for
example),
discolour the material (e.g. carrot juice) or
affect its odour (e.g. fennel tea). This has
no effect on the fitness for use or safety
of the bottle.
3. Next,
"5.2 Sterilising" on page 28).
4. Wipe the pump unit 3 with a damp cloth.

5.2 Sterilising

Before sterilising, clean as described in the
section entitled "5.1 Cleaning)".
Warning! Risk of scalding during
sterilisation.
Caution!
• Dismantle each part into its individual
components for boiling or steam-sterilizing
(temperature above 80 °C) and leave open,
otherwise deformation can result.
• The pump unit 3 and the mains adapter 13
must never be sterilised in this way, as this
can damage the electrical contacts and
cause deformation.
28
Warning! Milk residues may
damage the product and result
in microbial growth.
The parts should not be cleaned
certain foodstuffs
sterilise all
may
parts (see