Ottobock 50S20-1 Malleo Immobil Night Splint Gebrauchsanweisung Seite 9

2.2 Adapting and Applying the Product
The initial fitting and application of the orthosis must be carried out by
qualified personnel.
The orthosis is delivered ready for trial fitting.
1. To apply the orthosis, completely open it and position the foot in the
middle of the orthosis with the knee flexed (Fig. 1).
2. Close the ankle strap and set the hook and loop closure to a comfort-
able length (Fig. 2). Close the foot and calf strap similarly. (Fig. 3).
3. Extend the knee to ensure that the ankle and foot straps are firmly in
place. Readjust the hook and loop closure, if necessary (Fig. 4).
4. The hook and loop closures that support dorsal flexion can be incre-
mentally adjusted to increase or reduce the angle of the foot (Fig. 5).
2.3 Instructions for Use and Care
NOTICE
Damage caused by wear and tear. Before each use, the orthosis must
be checked for functional reliability and for possible wear or damage. If
a closure or any other part of the orthosis shows any signs of wear, the
orthosis should no longer be used.
Improper changes to the product are not permitted.
The orthosis must be used in strict conformity with the indication. The phy-
sician's instructions must be strictly observed.
Material: Foot bucket: Polypropylene; liner: polyester, foam, velour; hook
and loop straps: nylon; closure pad: polyester, foam, Velour; closures:
polypropylene; rivets: nylon; sole: Evazote.
Cleaning: Use a slightly moistened cloth to clean the outside of the ortho-
sis. Hand-wash the textile elements in 30 °C warm water with a standard
mild detergent. Soap residues can cause skin irritations; therefore, rinse
the orthosis thoroughly so that all soap residue is removed. Let air dry.
Do not expose to the sun and do not use oven or radiator heat for drying.
Disposal after usage: The material used in the product is recyclable and
should be disposed of accordingly.
Ottobock | 9