Device Configuration - Endress+Hauser RIA16 Kurz- Betriebsanleitung

RIA16
• Firstly, add the Communication DTM "PCP (Readwin) TXU10 / FXA291" to an empty
project.
• In the Comm DTM settings, set the baud rate to 2400 baud and select the COM-port used.
• Add the RIA14/16 Version Vx.xx.xx device DTM to the project using the "Add device..."
function.
Note! Online configuration is not possible with the RIA14/RIA16.
• To then configure the device itself, follow these Operating Instructions for the device. The
entire Setup menu, i.e. all the parameters listed in these Operating Instructions, can also be
found in the FieldCare Device Setup.
PC Configuration software
Fig. 11: Configuring the field indicator via interface adapter
In general, it is possible to overwrite parameters with the FieldCare PC software and the
appropriate device DTM even if access protection is active.
If access protection by means of a code should be extended to the software, this
function should be activated in the extended device setup.
5.5

Device configuration

Detailed information on device configuration can be found in the operating instructions.
Endress+Hauser
Configuration kit USB-Box
USB
Operating the field indicator
a0011272-en
37