Installation Location; Mounting Instructions; Direct Wall Mounting - Endress+Hauser RIA16 Kurz- Betriebsanleitung

Installation RIA16
3.2.1 Dimensions
a0011162
Fig. 2: Installation dimensions; dimensions in mm (dimensions in inches in brackets)
A: Bore hole for mounting to wall or optional mounting plate with 4 srews ∅ 5 mm (0.2") =

3.2.2 Installation location

Information on conditions that must be present at the installation location to mount the
device correctly can be found in Section 'Technical data'. These include the ambient
temperature, degree of protection, climate class etc.
3.3

Mounting instructions

The device can be mounted directly on the wall or the optional mounting plate can be used for
wall or pipe mounting (→ å 3).

3.3.1 Direct wall mounting

Proceed as follows to mount the device directly on the wall:
• Drill 4 holes
• Attach the device to the wall with 4 screws (∅5).
3.3.2 Pipe mounting
The mounting bracket is suited for pipes with a diameter between 1" - 5". The mounting kit
consists of a mounting plate (item 1), 2 clamps (item 2) and 4 screws (item 3) (→ å 3 and
→ å 4).
26 Endress+Hauser