Briggs & Stratton 020222 Bedienungsanleitung Seite 8

Briggs & Stratton Generac Generator Discount Parts Call 606-678-9623 or 606-561-4983
HOW TO USE PRESSURE
WASHER
If you have any problems operating your pressure washer,
please contact the local Briggs & Stratton service center.
Pressure Washer Location
Pressure Washer Clearance
Running engine gives off carbon monoxide, an
odorless, colorless, poison gas.
Breathing carbon monoxide will cause nausea,
fainting or death.
• Operate pressure washer ONLY outdoors.
• Keep exhaust gas from entering a confined area through
windows, doors, ventilation intakes or other openings.
• DO NOT operate pressure washer inside any building or
enclosure.
The pressure washer must be at least 5 ft. (152 cm) from
structures having combustible walls and/or other
combustible materials. Leave at least 3 ft. (92 cm) all around
pressure washer including overhead, for adequate cooling,
maintenance and servicing.
Place pressure washer in a well ventilated area, which will
allow for removal of deadly exhaust gas. DO NOT place
pressure washer where exhaust gas could accumulate and
enter inside or be drawn into a potentially occupied
building. Ensure exhaust gas is kept away from any
windows, doors, ventilation intakes or other openings that
can allow exhaust gas to collect in a confined area
(Figure 6). Prevailing winds and air currents should be taken
into consideration when positioning pressure washer.
Figure 6 — Pressure Washer Clearance
BSPP 1950 PSI Pressure Washer
DANGER
Typical Pressure
Washer Shown
Exhaust Port
www.mymowerparts.com
How To Start Pressure Washer
To start your pressure washer for the first time, follow
these instructions step-by-step.This starting information
also applies if you have let the pressure washer sit idle for
at least a day.
1. Place pressure washer near an outside water source
capable of supplying water at a flow rate greater than
3.0 gallons per minute and no less than 20 PSI at
pressure washer end of garden hose.
2. Check that high pressure hose is tightly connected to
spray gun and to pump. See "Preparing Pressure
Washer for Use" for illustrations.
3. Make sure unit is in level position.
4. Connect garden hose to water inlet on pressure
washer pump. Turn ON the water.
CAUTION
DO NOT run the pump without the water supply
connected and turned on.
• Damage to equipment resulting from failure to follow this
instruction will void warranty.
5. Attach adjustable nozzle extension to spray gun
(Figure 7).Tighten by hand.
Figure 7 — Connect Nozzle Extension to Spray Gun
6. Position nozzle in low pressure mode (see "How To
Use Adjustable Nozzle") and squeeze trigger on spray
gun to relieve air pressure caused by turning ON
water.Water will flow out of spray gun in thin stream.
Continue to hold trigger until steady stream of water
occurs and no air remains in system.This will make it
easier to pull start the engine. Release trigger.
7. Engage trigger lock to spray gun trigger (Figure 8).
Figure 8 — Spray Gun with Trigger Lock Engaged
8
Trigger Lock