SOMFY Power 4x2.5 DC RTS Gebrauchsanleitung Seite 30

F ADDING AND DELETING
F.1) Adding or deleting a transmitter or a
A
sensor.
Press the programming button on the Power
4x2.5 DC RTS Receiver or the transmitter
A until the blind moves up and down. Then
press the programming button on transmitter
B. It is either saved if the transmitter is new or
B
deleted if the transmitter is recognized.
Remark : If no remote control is paired, You
can use this mode for the 1st pairing.
F.2) Deleting all transmitters and sensors.
Press the programming button on the Power
4x2.5DC RTS Receiver for approximately
7 seconds. The blind moves up and down
twice:
First time for approximately 2 seconds.
Second time for approximately 7 seconds.
All transmitters have been deleted.
F.3) Back to factory mode
2 X
Press the programming button on the Power
4x2.5 DC RTS Receiver for approximately
12 seconds. The blind moves up and down
three times:
First time for approximately 2 seconds.
Second time for approximately 7 seconds.
Third time for approximately 12 seconds.
All transmitters and sensors are deleted, up
and down motion durations are deleted.
The product settings are back to default
factory configuration.
3 X
28 Copyright © 2010 Somfy SAS. All rights reserved - V0 - 04/2010