Specifications And Technical Data - Max TA238B/18-6(CE) Betriebsanleitung

 The tool must be used only for the purpose it was
designed.
 Never remove, tamper with the operating controls
(e.g., TRIGGER, CONTACT ARM)
 Keep the tool in a dry place out of reach of chil-
dren when not in use.
 Do not use the tool without Safety Warning label.
 Do not modify the tool from original design or
function without approval by MAX CO., LTD.
 Do not use the tool when you feel something un-
usual. (Air leak, strange noise, operating unusual-
ly.)
2. SPECIFICATIONS AND TECHNI-
CAL DATA
1. NAME OF PARTS
2
7
1
6
4
5
10
2. TOOL SPECIFICATIONS
PRODUCT NO.
HEIGHT
WIDTH
LENGTH
WEIGHT
RECOMMENDED OPERATING
PRESSURE
LOADING CAPACITY
AIR CONSUMPTION
 The machine has been compactly designed in order to im-
prove operating weight balance.
3. FASTENER SPECIFICATIONS
CROWN 6.4mm (1/4'')
LENGTH 13 to 38mm
(1/2''to1-1/2'')
WIDTH 1.25mm (.05'')
THICKNESS 1.12mm (.044'')
GAUGE
1 Frame
2 Cylinder Cap
3
3 Exhaust Port
4 Slider Unit
5 Magazine
6 Trigger
8 7 Grip
8 Click Lever
9 Warning Label
(back side)
0 Outlet
9
TA238B/18-6
241.5mm (9-1/2")
64mm (2-1/2")
231mm (9-1/8")
1.2kg (2.71lbs)
5 to 7bar
(70 to 100 p.s.i.)
109staples
3
0.61l(0.022ft ) at 7 bar
operating pressure
18
CROWN
LENGTH
THICKNESS
TOOL AIR FITTINGS:
This tool uses a 1/4"N.P.T. male plug. The inside diameter should
be 7mm (.28") or larger. The fitting must be capable of discharg-
ing tool air pressure when disconnected from the air supply.
RECOMMENDED OPERATING PRESSURE:
5 to 7 bar (70 to 100 p.s.i.). Select the operating air pressure with-
in this range for best fastener performance.
DO NOT EXCEED 8.3 bar (120 p.s.i.).
4. TECHNICAL DATA
1 NOISE
A-weighted single-event sound power level
A-weighted single-event emission sound pressure level at
work station
These values are determined and documented in accord-
ance with EN12549 : 1999.
2 VIBRATION
Vibration characteristic value
These values are determined and documented in accord-
ance with ISO 8662-11.
This value is a tool-related characteristic value and does not
represent the influence to the hand-arm-system when using
the tool. An influence to the hand-arm-system when using
the tool will, for example, depend on the gripping force, the
contact pressure force, the working direction, the adjustment
of mains supply, the workpiece, the workpiece support.
5. APPLICATIONS
 Door and window casings
 Plywood, decorative boards, and other interior finish works
 Panel assembly and moldings
 Sub flooring
 Furniture assembly including drawer assembly, case back fas-
tening, blind pinning, and other finishing works
 Cabinet assembly
6
WIDTH
------ LWA, 1s, d 85.1 dB
Uncertainty (KWA): 3 dB
------- LpA, 1s, d 83.2 dB
Uncertainty (KpA): 3 dB
2
= 2.93 m/s
2
Uncertainty(K): 1.5 m/s