Restoring The Original Configuration - SOMFY S&SO-RS100 io Anleitung

2.4.5. Restoring the original configuration
Apply the double cutout only for the end-product to
be reset.
This reset deletes all programmed control points, all
sensors, all end limit settings and resets the favourite
(my) position for the drive.
Position the roller shutter at its half-way position.
1)
Cut the power supply for 2 seconds.
2)
Switch the power supply back on for 5 to 15 seconds.
3)
Cut the power supply for 2 seconds.
4)
Switch the power supply back on: the roller shutter
5)
moves for a few seconds.
Press the PROG button on the Somfy io-homecontrol
6)
control point for ≈ 7 s, until there are two back and
forth movements by the roller shutter:
The drive is now reset to its original configuration.
→
Resume the set-up operation (see Set-up section).
-
Copyright © 2014 - 2016 Somfy SAS. All rights reserved.
1)
5 s
3)
ON
15 s
5)
ON
®
6)
PROG. 7 S
Non contractual images.
EN
2)
OFF
2 s
4)
OFF
2 s
my
X 2
45