When cleaning with solvents (except water) always switch off the heating element! The
solvent containers (except for water) must be earthed!Caution!. Do not pump or spray into
containers with a small opening (bung hole)! Refer to the safety regulations.
Warm water facilitates the cleaning process for water-soluble coating materials. The hea-
ting hose can be switched on for this
Cleaning the unit from outside
First remove the mains plug from the socket. Risk of short circuit as a result of water penet-
ration!
Never spray the unit using a pressure washer or steam cleaner.
Wipe the outside of the unit using a cloth soaked in a suitable cleaning agent.
8. Technical data
Nominal voltage:
Controllable heat output:
Temperature control range:
Temperature setting:
Signal relay:
Protection class
Protection type:
Ambient temperature:
Connecting
Length:
Plug type:
Dimensions in mm:
Terminals:
Screw connections:
9. 1. Repairing the unit
Defective hoses, heating elements and temperature regulators should only be repaired by authorised
STORCH service centres. Please contact the STORCH service hotline on 0800 / 7867247 for further infor-
mation.
230V/50Hz
3600W (or max. 16A)
20 to 80°C
digital via buttons on the heating controller
change-over relay 230V AC, max. 6A
I
DIN 40050 IP65 when plugged in
0 to +50°C (storage temperature: –40°C to +70°C)
cable (only –D) H05 VV-F 3G 1.5
1.3m
Euro 16A
81x161x65 (WxLxH) - ABS housing without screw connection/base plate
2.5mm²
2xM16x1.5
44