Safety Regulations For Paint Spraying - Storch HotFlow Bedienungsanleitung

WARNING!
Please observe the safety precautions for your airless unit
The device possesses a voltage range which can pose an electrical hazard to humans and animals.
This should only be screwed and / or disassembled by authorised personnel.
Similarly, maintenance and repair work should only be conducted by electrical specialists and authorised
service centres.
The buyer / user operates the device at their own risk and under their own responsibility.
1. It should always be ensured that the heating hose is earthed.
The system is not explosion-proof. Exercise caution when using flammable material.
2. Before conducting any operation the following points must be observed in accordance with the
manual:
a) Faulty equipment should not be used.
b) Make sure the unit is earthed.
c) Check the permissible operating pressure on the airless unit.
d) Check all connecting parts for leaks.
e) Wear personal protective equipment.
f) The HotFlow 7.5 m heating hose system (art.no.: 691505) should not be connected to the
following STORCH airless units: LP 400, LP 460, LP 540, LP 690 and SL 1100.
3. Instructions relating to regular cleaning and maintenance of the unit must be observed!
Before starting any work on the unit or having a break from work observe the following rules:
a) Discharge pressure (spray gun and airless hose).
b) Secure the spray gun by applying the safety lever to the trigger.
c) Switch off the unit.
Pay attention to your safety!

1. Safety regulations for paint spraying

The safety-specific requirements for airless spraying are regulated in:
a) European Standard (EN 1953: 1998)
„Atomising and spraying equipment for coating materials - Safety requirements"
b) Regulations of the employer's liability insurance association for health and safety at work
„Operation of work equipment" (BGR 500, Part 2 Section 2.29 and 2.36)
c) Directives of the employer's liability insurance association
The safety precautions provided by the manufacturer of your airless unit are to be observed for safe
operation of airless spraying equipment.
The following additional safety regulations are to be observed when using heating hoses:
39