Intended Use - VOLTCRAFT VC175 Bedienungsanleitung

INTENDED USE

Measuring and displaying electric parameters in the range of excess voltage category III (up to max.
600 V against ground potential, pursuant to EN 61010-1) and all lower categories.
• Measuring direct and alternating voltage up to a maximum of 600 V
• Measurement of direct and alternating current up to 10 A
• Measuring of resistance up to 40 MΩ
• Acoustic continuity check
• Diode test
• Non-contact 230 V/AC voltage test
• Electric current measurement
The two measuring inputs are secured against overload. The voltage in the measuring circuit may not
exceed 600 V. The measuring ranges are equipped with ceramic high-performance fuses.
The device may only be operated with a 9 V block battery.
The measuring instrument must not be operated when it is open, i.e. with an open battery compartment
or when the battery compartment cover is missing. Measuring in damp rooms or under unfavourable
ambient conditions is not admissible.
For safety reasons, when measuring only use measuring cables or accessories which are adjusted to
the specifications of the multimeter.
Unfavourable ambient conditions are:
• Wetness or high air humidity,
• Dust and flammable gases, vapours or solvent,
• Thunderstorms or similar conditions such as strong electrostatic fields etc.
Unauthorised conversion and/or modification of the device are inadmissible because of safety and
approval reasons (CE). Any usage other than described above is not permitted and can damage the
product and lead to associated risks such as short-circuit, fire, electric shock, etc. Please read the
operating instructions thoroughly and keep them for further reference.
This product complies with the statutory national and European requirements. All company names
and product names are trademarks of their respective owners. All rights reserved.
Observe all safety instructions and information within this operating manual.
27