Correct Electrical Installation - Oase Water Trio Gebrauchsanleitung

Hazards encountered by the combination of water and electricity
• The combination of water and electricity can lead to death or severe injury from electrocution, if the unit is incorrectly
connected or misused.
• Prior to reaching into the water, always switch off the mains voltage to all units used in the water.

Correct electrical installation

− Electrical installations at garden ponds must meet the international and national regulations valid for installers.
Especially adhere to DIN VDE 0100-702.
− Only use cabes admitted for external use and meeting DIN VDE 0620.
− Ensure that the transformer is protected by a rated fault current of max. 30 mA via a fault current protection de-
vice.
− Only connect the transformer when the electrical data of the power supply is identical to that on the type plate.
− Only operate the transformer when plugged into a correctly fitted socket.
− For your own safety, consult a qualified electrician when you have questions or encounter problems.
Safe operation of the unit
− Keep socket and power plug dry.
− Route the power cables so that damage is excluded.
− Do not carry or pull the units by the connection cables. The power connection cables cannot be replaced. If the
cable is damaged, the entire unit has to be disposed of.
− Never run the pump without water! Otherwise the pump will be destroyed.
− Never use the pump for fluids other than water. Other fluids could destroy the unit.
− Never open the unit or its attendant components, unless this is explicitly mentioned in the operating instructions.
− Never carry out technical modifications to the unit.
− Only use original spare parts and original accessories for the unit. Only have repairs carried out by authorised
customer service points.
− Never look directly into the light source of the unit. The light beam's intensity could irreversibly damage the retina.
Installation
Attention! Dangerous electrical voltage.
Possible consequences: Death or severe injury.
− Install transformer and 12 V control box at a dry, splash-water protected place. Additionally protect the
12 V control box against sun radiation (max. 40 °C).
− During operation, ensure that both the transformer and the 12 V control box are placed at a 2 m sa-
fety distance from the bank (D).
Installing the Water Trio / Water Quintet (B, C):
Variant 1 (B):
− Install the unit as horizontally as possible in the water on a firm ground.
− The minimum water level must be just above the pumps (8).
Variant 2 (C):
In the case of excessive water depth, the extension tubes (6) can be used to compensate. If not sufficient, select a dif-
ferent suitable place of installation.
− To open, release the nozzle holders (9) by slightly turning them at the housing top section (10) and remove.
− Unscrew the LED light nozzle (11).
− Screw the extension tubes (6) between the LED light nozzles (11) and the pumps (12).
− Close the unit by placing the housing top section (10) on the LED light nozzles (11) and fasten using the nozzle
holders (9).
− Install the unit as horizontally as possible in the water on a firm ground.
− The minimum water level must be just above the pumps (8).
Note: Ensure that the water inlet at the unit underside is not impaired!
- GB -
13