Herunterladen Inhalt Inhalt Diese Seite drucken

Correct Electrical Installation; Safe Operation - Oase Jumping Jet Rainbow Star DMX/01 Gebrauchsanleitung

Vorschau ausblenden Andere Handbücher für Jumping Jet Rainbow Star DMX/01:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

3.2

Correct electrical installation

► Electrical installations must meet the national regulations and may only be carried out by a qualified
electrician.
► A person is regarded as a qualified electrician, if, due to his/her vocational education, knowledge and
experience, he or she is capable of and authorised to judge and carry out the work commissioned to
him/her. This also includes the recognition of possible hazards and the adherence to the pertinent
regional and national standards, rules and regulations.
► For your own safety, please consult a qualified electrician.
► The unit may only be connected when the electrical data of the unit and the power supply coincide.
The unit data is to be found on the unit type plate or on the packaging, or in this manual.
► Ensure that the unit is fused for a rated fault current of max. 30 mA on the mains side by means of a
fault current protection device.
► Ensure that on the unit side the voltage supply is dc decoupled from the mains.
3.3

Safe operation

► Only operate the unit if no persons are in the water.
► Never operate the unit with a water pressure above 0.5 bar.
► Never connect the unit to the domestic water supply.
► Never operate the unit if either the electrical cables or the housing are defective!
► Do not carry or pull the unit by its electrical cable.
► Route cables/hoses such that they are protected from damage and do not present a tripping hazard.
► Only open the unit housing or its attendant components, when this is explicitly required in the operating
instructions.
► Only carry out work on the unit that is described in this manual. If problems cannot be overcome,
please contact an authorised customer service point or, when in doubt, the manufacturer.
► Only use original spare parts and accessories for the unit.
► Never carry out technical modifications to the unit.
► Never look directly into the light source of the unit.
► Place the unit such that any risk of injury for persons is excluded (e.g. by a light beam or water jet
suddenly occurring).
- EN -
17

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis