Maintenance And Cleaning - Oase Water Trio Gebrauchsanleitung

The manual transmitter as part of our scope of delivery is taught in for the 12 V control box. The 12 V control box has
to be adapted to every further manual transmitter.
Teaching-in manual transmitter (J):
The receiver is equipped with a teach-in button (24) to adapt the 12 V control box to the transmission signal of the ma-
nual transmitter.
− Insert a pin (23) into the opening for the teach-in button (24) until you feel a resistance. Keep pressing in the
pin (23) until this resistance is overcome. The teach-in button (24) is then activated.
− Actuate the teach-in button (24) using the pin (23) for approx. 1 sec.
− Then press any button of the manual transmitter for at least 1 sec.
Deleting the manual transmitter (J):
− Actuate the teach-in button (24) using a pin (23) for at least 5 sec.
This deletes all manual transmitters stored in the receiver.
Note: A maximum of 10 manual transmitters can be set to the receiver. The manual transmitter has a maximum range
of 80 m. Obstacles between transmitter and receiver, a low battery in the manual transmitter, or electro-magnetic radia-
tion of electrical equipment will impair the range.
− Aligning the water jet (K):
− Adjust the individual movable nozzles to align the water jet (5).

Maintenance and cleaning

Disconnect the power plugs of all other units in the water prior to starting work on the unit (I)!
Cleaning the unit (L, M, N):
− To open, release the nozzle holders (9) by slightly turning it at the housing top section (10) and remove.
− Unscrew the LED light nozzles (11) and, if fitted, the extension tubes (6) (see Fig. C).
− Laterally slide the respective pump (26) out of the engagement holder of the filter basket (27).
− Slightly turn the pump cover to disengage (28), then remove the impeller (29).
− Clean all components under running water using a brush.
Reassembling the unit:
Reassemble the unit in the reverse order (L, M, N).
Note: Push the pump housing into the filter basket until it tangibly engages.
Battery change in the manual transmitter (O, P):
Improper handling can lead to damage to the manual transmitter!
Touch a bare metal surface (e.g. a radiator) to discharge static charges, which could lead to damage to the
internal components of the manual transmitter!
Ensure that neither dirt nor moisture can enter the manual transmitter!
− Guide a slot screwdriver (30) into the lateral opening (31) of the manual transmitter.
− Open the manual transmitter housing by slightly turning the screwdriver, then remove the housing bottom sec-
tion (32).
− Pull the battery (33) out of the holder (34).
− Push the new battery into the holder (34). Ensure that the embossed side (35) of the battery points upward.
Storage/Over-wintering
Remove the unit at temperatures below zero degrees centigrade. Thoroughly clean and check the unit for damage.
Store the Water Trio / Water Quintet frost protected and submersed in a water filled container. Do not immerse the
plug.
- GB -
15