Starting The Compressor - Comprag A0708 Bedienungsanleitung

Emergency messages
WARNING signal
Code
Е:0010 Emergency shutdown
Е:0020 Motor overload
Lack of one phase or incorrect phase
Е:0050
sequence
Е:0115 Pressure sensor failure
Е:0119 Pressure exceeds set emergency pressure
Е:0125 Temperature sensor failure
Е:0129 Temperature of oil-air mixture above 107°C
4.3 Staring the compressor
Switch on the voltage.
Open the air outlet valve.
Press button "Start" on the control panel.
The compressor starts running in an automatic operation mode, controlled by the e-Log
electronic controller.
COMPRAG Screw air compressor A-Series
flashes when compressor has been stopped.
Error
Before staring check oil level at sight glass on the Air-Oil separa-
tion tank.
Action
The emergency shutdown button has been
pressed; once the situation has been rem-
edied, the button can be unblocked.
Check operability of electric motor, thermal
relay setting, belt tension and the air tem-
perature on the control panel
Check for phase and put the power cable in
phase
Check connection and change sensor if
necessary
Reduce pressure in airline system
Check connection and change sensor if
necessary
Check the oil level, oil filter, thermostat
function and for contamination of the heat
exchanger
27