Setting The Dial Mode; Setting The Flash Time - switel DET 2872C Bedienungsanleitung

Setting the telephone
Setting Call Barring (handset only)
/
/
/
/
☞
If barring mode is set to on and the dialling number matched with any one of the set bar
numbers, the dialling procedure will be aborted with "CALLS BARRED" shown in the display.
Select a base station (handset only)
/
/
/
☞
You can only select a base station your handset is already registered to.

Setting the dial mode

/
/
/
☞
In most situations the TONE option should be selected.

Setting the Flash Time

/
/
/
18
Press the menu key.
Select HS SETTINGS and press OK.
Select BARRING and press OK.
Enter the relevant PIN (default 0 0 0 0) and press OK.
Select ON and press OK.
Select a number 1 ... 4 and press OK.
Enter enter a max. 4 digit number and press OK. If barring mode is set to on, your
phone will check the first 4 digits of the dialling number with the set bar numbers.
Press the menu key.
Select HS SETTINGS and press OK.
Select SELECT BASE and press OK.
You see a list of base stations. The relevant base is marked with a "+". Select a base
and press OK.
Press the menu key.
Select SETTINGS (on the desktop telephone) or BS SETTINGS (on the handset) and
press OK.
Select DIAL MODE and press OK.
Select TONE or PULSE and press OK.
Press the menu key.
Select SETTINGS (on the desktop telephone) or BS SETTINGS (on the handset) and
press OK.
Select FLASH TIME and press OK.
Select 100 (ms), 250 (ms), 600 (ms) or 1000 (ms) and confirm with OK.