Introduction; Safety Instructions; Operating Instructions - Futurelight Scan H - 150 Bedienungsanleitung

CAUTION !
Keep this device away from rain and moisture !
Unplug mains lead before opening the housing !
For your own safety, please read this user manual carefully before you initial start-up.
Every person involved with the installation, operation and maintenance of this device have to:
- be qualilfied
- follow the instructions of this manual
CAUTION ! Be careful with your operations.
With a voltage of 230 V you can suffer a dangerous
electric shock when touching the wires !

1. Introduction

Thank you for having chosen a FUTURELIGHT SCAN H-150. You will see you have acquired a powerful and
versatile device.
Unpack your SCAN H-150.
Before you initial start-up, please make sure that there is no damage caused by transportation. Should there be
any, consult your dealer and do not use the device.

1.1 Safety instructions

This device has left our premises in absolutely perfect condition. In order to maintain this condition and to ensure
a safe operation, it is absolutely necessary for the user to follow the safety instructions and warning notes written
in this user manual.
Important:
Damages caused by the disregard of this user manual are not subject to warranty. The dealer will not accept
liability for any resulting defects or problems.
If the device has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it on
immediately. The arising condensation water might damage your device. Leave the device switched off until it has
reached room temperature.
During the initial start-up some smoke or smell may arise. This is a normal process and does not necessarily
mean that the device is defective.
Please consider that damages caused by manual modifications to the device are not subject to warranty.

1.2 Operating instructions

This device was designed for indoor use only.
Do not shake the device. Avoid brute force when installing or operating the device.
You can install the device at any desired place. Please make sure that the device is not exposed to extreme heat,
moisture or dust. There should not be any cables lying around. You endanger your own and the safety of others!
Operate the device only after having familiarized with its functions. Do not allow an operation by persons who do
not know the device well enough. Most damages are the result of an unprofessional operation!
Caution: If the FUTURELIGHT HC-controller is to be used, it is absolutely necessary to plug a 6.35mm-stereo-
Jack plug in the DMX IN jack of the master-device.
Please consider that for safety reasons unauthorized modifications to the device are forbidden!
When taking the device into operation, please make sure that the housing is closed firmly with all the necessary
screws tightened up.
1 1