Jackle Plasma 40i IP23 Betriebsanleitung Seite 14

General information's:
These operating instructions are intended to ensure safe and efficient work with this cutting unit.
Prior to initial operation of the unit, read the instructions carefully.
The information contained in this manual should be made available to all operational staff. These
instructions should always be kept ready-to-hand, near the machine.
Electromagnetic compatibility EMC (IEC 60974-10):
WARNING: This class A cutting unit is not provided for use in housing areas, where the electric
power supply comes from a public low voltage supply.
It may possible, that through wire fixed or radiate disturbances, it isn't easy to guarantee
electromagnetic compatibility in these areas.
INFORMATION: The user is responsible for the trouble, which the machine generates during the
operation. He must rate and consider possible electromagnetic problems in the neighbourhood.
Warranty:
INFORMATION: Improper repair or servicing, technical modifications of the product, unauthorized,
not strictly from JÄCKLE GmbH permitted modifications, as well as carelessness at the installation or
use, or the non observance of care in own affairs lead to the extinction of every warranty.
within the meaning of EC recommendation EMC 2004/108/EG
respectively of EC recommendation 2006/95/EG
Manufacturer:
We declare, that below mentioned current source corresponds to the safety
requirements of the recommendations.
Name of unit:
Type of unit:
Relevant
EC recommendations:
Applied
harmonised standards:
Especially:
Jäckle Schweiß- und Schneidtechnik GmbH
Reinhard Jäckle
Operating manual
DECLARATION OF CONFORMITY
Jäckle Schweiß- und Schneidtechnik GmbH
Riedweg 4+9
D – 88339 Bad Waldsee
Germany
Plasma cutting Unit
Plasma 40 IP23, Plasma 40 IP44
EMC recommendation 2004/108/EG
Low-voltage recommendation 2006/95/EG
EN 60 974-10
EMC product standard
for arc welding equipment
EN 60 974-1
Arc welding equipment / Welding power sources
Plasma 40i
Page 12