Replacing The Lamp; Closing The Door; Installation - AEG S84000KMW0 Benutzerinformation

Problem
The temperature in
the refrigerator is
too warm.
The appliance does
not operate.
The lamp does not
work.
Door interferes with
ventilation grill.
Misaligned door.
As much as the advice does not lead to result, call the nearest brand-mark service.

7.1 Replacing the lamp

The appliance is equipped with a long-
life LED interior light.
Only service is allowed to replace the
lighting device. Contact your Service
Center .

7.2 Closing the door

1. Clean the door gaskets.

8. INSTALLATION

WARNING!
Read the "Safety Information"
carefully for your safety and cor-
rect operation of the appliance
before installing the appliance.
Possible cause
There is no cold air circu-
lation in the appliance.
Large quantities of food
to be cooled were put in
at the same time.
The appliance is switched
off.
The mains plug is not
connected to the mains
socket correctly.
The appliance has no
power. There is no volt-
age in the mains socket.
The lamp is defective.
The door has been open
to long.
The appliance is not lev-
elled.
The appliance is not lev-
elled.
2.
3.
8.1 Positioning
Install this appliance at a location where
the ambient temperature corresponds to
the climate class indicated on the rating
plate of the appliance:
Solution
Make sure that there is
cold air circulation in the
appliance.
Insert smaller quantities of
food to be cooled at the
same time.
Switch on the appliance.
Connect the mains plug to
the mains socket correctly.
Connect a another electri-
cal appliance to the mains
socket. Check fuse. Con-
tact a qualified electrician.
Refer to "Replacing the
lamp".
Close the door.
Refer to "Levelling".
Refer to "Levelling".
If necessary, adjust the door. Refer
to "Installation".
If necessary, replace the defective
door gaskets. Contact the Service
Center.
ENGLISH
31