Electrical Connection - AEG S84000KMW0 Benutzerinformation

8.4 Levelling

8.5 Electrical connection

Your appliance must be connected to a
single-phase supply of 230 V. Check that
the electricity meter is suitable for the
power consumed by your appliance, al-
lowing for the other connected applian-
ces. Rating of the in-line fuses (one per
phase): 10 A at 230 V.
Installation must be done in con-
formance with the applicable co-
des, the requirements of the
standard NF.C.15100 and the re-
quirements of the electrical ener-
gy supplier.
Use a power supply socket that has an
earth connection and this must be con-
nected in conformance with the stand-
8.6 Installation of the Taste Guard Filter
Accurate levelling prevents the vibration
and noise of the appliance during opera-
tion. To adjust the height of the appli-
ance loosen or tighten the two adjusta-
ble front feet.
ard 15100 and the requirements of the
supplier of electrical energy. this power
supply socket must be accessible. If the
mains supply cable is damaged, it must
be replaced by a certified supply cable.
This must be done only by a skilled per-
son, the seller or the manufacturer. The
appliance must not be connected via an
extension cable, a multiple socket or a
multiple connector (risk of fire). Make
sure the earthing connection complies
with the regulations in force.
We will accept no responsibility in the
event of accidents or incidents caused
by non-existent or defective electrical
earthing connections.
The Taste Guard Filter is an active car-
bon filter which absorbs bad odours
maintain the best flavour and aroma for
all foodstuffs without risk of odour cross
contamination.
On delivery the carbon filter is in a plas-
tic bag to preserve performance.
• Open the air lever flap.
• Take the filter out of the plastic bag.
ENGLISH
33